Vacon DPD00109 Installationshandbuch PDF herunterladen (Seite 9)

Keypad Remote Control Options vacon  9

Email: [email protected] • Fax 717-264-3115

Step 5. Installing the Remote Keypad Assembly into the Host Enclosure (XRKPM only)

1. Position the remote keypad assembly into the enclosure prepared in Step 1 (page 4).

2. Fasten the keypad module with the four (4) M5 x 12 screws provided, limiting torque to 26 in-lb maximum.

3. Install a cable clamp below the keypad assembly as shown in the drawing, fastening it to the host enclosure.

Connect the ribbon cable to the J1 connector and route it through the cable clamp. The cable should exit the

keypad module downward.

4. Route the cabling as needed to avoid any damage. Additional cable clamps are provided to allow strain relief

for the wire.

Figure 5: Installing the Remote Keypad Assembly into the Host Enclosure (XRKPM Option)

For detailed information on using the keypad, refer to the following documentation:

• DPD 00088, X4 AC Drive User’s Manual

• DPD 00089, X5 AC Drive User’s Manual

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Keine Kommentare

Vacon DPD00109 Installationshandbuch Seite 9